HP A4923-69101 - 512MB ECC high-density SDRAM DIMM memory module - Must be installed in pairs of equal size (1024MB kit is A4923A) Retail
HP A3763-69201 - 256MB ECC high-density SDRAM DIMM memory module - Must be installed in pairs of equal size (512MB kit is A3763A) Retail
HP A3639-00104 - Hot-swap hard drive tray - Metal tray for mounting 3.5-inch internal hot-swap hard disk drives Retail
HP A6089-69001 - 36GB hot-plug Ultra-2 Low Voltage Differential (LVD) SCSI SCA hard drive - 10,000 RPM, low profile (Seagate ST336704LC) Retail
HP A5531-69003 - 18GB hot-plug Ultra SCSI Low Voltage Differential (LVD) SCA hard drive - 10,000 RPM, low profile (Seagate ST318203LC) Retail
HP A3639-00103 - Center support brace - Mounts in the middle of the system board section of the chassis Retail
HP D4946-69001 - System processor board - With Super VGA video, Ultra SCSI controller, IDE controller - System (Mother) Board - with Super VGA Video, Ultra SCSI Controller, IDE Controller - Large Vertical Board in Center of Chassis Retail
HP D4944-69001 - Processor board - Has one processor socket - Does NOT include the processor - Processor Board (Small Horizontal Board) - Has One Processor IC Socket - Does NOT Include the Processor IC Retail
HP 5064-0701 - Fan assembly - With housing - Mounts to the rear panel in the upper slot (above the power supply assembly) Retail
HP 5182-9423 - SCSI-2 90 ohm ribbon cable with termination (C31) - Cable is marked `Int. SCSI extension cable C31-90 ohm` - 50-pin (F) connector marked `To array back plane` and three 50-pin (F) connectors marked `To unterminated SCSI drive` - 48.3cm Retail
HP 5182-6789 - Floppy drive ribbon cable - 34-pin (F) connector marked `to system board` to a 34-pin (F) old-style edge connector and a 34-pin (F) new-style connector marked `to 3.5 inch flexible disk drive` - 61.9cm (24.4in) long Retail
HP 5182-6788 - Ribbon cable for one IDE drive - 40-pin (F) connector to 40-pin (F) connector - 51cm (20in) long Retail
HP 0950-3066 - Voltage regulator module (VRM, VRE) - 5VDC input, 2.1-3.5VDC output, 10A, 32W - For Pentium Pro processors - Plugs in socket(s) on processor board Retail
HP D4842-69001 - Processor board - Has two processor sockets, two VRM sockets, and four DIMM sockets - Processor Board (Small Horizontal Board) - Has Two Processor IC Sockets, Two VRM Sockets, and Four DIMM Sockets Retail
HP 5042-2122 - Rubber foot - Replacement rubber foot for the bottom of the computer (two used) Retail
HP 5002-3279 - Hold down bracket - Metal bracket which secures add-in EISA or PCI cards to motherboard Retail
HP 5063-8380 - Bezel assembly - Has cut outs for switches and LED activity lights - Plastic cover over the control panel PC board Retail
HP JY271-61001 - Aruba FIPS/TAA multi-service controller module mark I, 10x 1000Base-X (SFP), 2x 10GBase-X (XFP), with 128-access point module Retail
HP JY269-61001 - Aruba multi-service controller module mark I, 10x 1000Base-X (SFP), 2x 10GBase-X (XFP), 16-access point module Retail
HP JY265-61001 - Aruba multi-service controller module mark I, 10x 1000Base-X (SFP), 2x 10GBase-X (XFP), (0 AP support) Retail
HP D8520-63021 - Technical reference card - Includes: power and mass storage cabling, service information, system board diagram, drive locations and settings Retail
HP D8520-63014 - Processor slot terminator module - Plugs into second processor slot when only one processor is installed Retail
HP D8510-69000 - Intel Pentium III `600EB` processor - 600MHz (Coppermine, 133MHz front side bus, 256KB Level-2 cache) - Includes heat sink Retail
HP D8520-63001 - Redundant hot swap power supply - Autoranging 100-240VAC input, 350 watts - Located in the back of the chassis Retail
HP D8520-69000 - System processor board - For up to two PIII processors with 133MHz FSB - Has integrated dual channel Ultra-2 SCSI controller, ATI Rage IIc video, and four DIMM sockets Retail
HP D8520-63013 - Hot-swap fan assembly - Includes three fans - Mounts in the fan Tray in the center of the chassis assembly Retail
