High-reliability 150GB M.2 2280 SATA III solid-state drive designed primarily as an OS / boot device in enterprise rack and tower servers that support SATA-based M.2 storage. This module uses the SATA 6Gb/s interface (NGFF, not PCIe NVMe) and a compact 22 x 80 mm form factor, making it ideal for dense ProLiant platforms with optional dual-M.2 boot enablement kits.
Engineered as a read-intensive drive, it is well-suited for operating systems, hypervisors, and light application workloads where fast read performance and robust endurance are required without the cost of high-write “mixed use” media. All shipped units match the electrical, mechanical, and firmware family used in supported enterprise servers (see interchangeable part numbers and compatibility below).
Typical Applications:
(The following part numbers refer to the same 150GB M.2 2280 SATA 6G RI drive family and are functionally interchangeable within supported platforms.)
VR000150GWEPP, 870143-001, 875317-B21, 875835-001
Please note that the following list is not exhaustive. Compatibility depends on your system's specific configuration. It's essential to verify compatibility with your system or enclosure manufacturer prior to installation.
✔️ HPE ProLiant DL360 Gen10 (requires supported M.2 SATA enablement / boot kit)
✔️ HPE ProLiant DL380 Gen10 (with supported M.2 SATA enablement / boot kit)
✔️ HPE ProLiant DL160 Gen10, DL180 Gen10 (with optional M.2 boot kit installed)
✔️ HPE ProLiant DL20 Gen10 (configurations supporting SATA M.2 boot)
✔️ HPE ProLiant DL325 Gen10 / DL385 Gen10 families (selected configurations with SATA M.2 support)
✔️ HPE ProLiant DL560 Gen10 / DL580 Gen10 (when equipped with compatible M.2 SATA boot options)
✔️ HPE ProLiant DL360 Gen9, DL380 Gen9 (systems configured with dual-M.2 SATA boot enablement kit for 2280 drives)
✔️ HPE ProLiant ML110 Gen10, ML350 Gen10 (configurations supporting SATA M.2 2280 boot devices)
✔️ HPE Nimble dHCI and other HPE solutions that explicitly specify 150GB M.2 SATA 6G RI 2280 boot drives
☑️ Enterprise-grade 150GB M.2 2280 SATA III SSD designed as a dedicated OS / boot drive for ProLiant-class servers
☑️ Read-intensive media optimized for high read workloads, ideal for hypervisors and infrastructure services
☑️ Compact 22 x 80 mm M.2 form factor frees up drive bays for data volumes and storage expansion
☑️ SATA 6Gb/s NGFF interface for broad support on platforms using SATA-based M.2 boot enablement kits
☑️ Fully compatible with HPE option and spare part numbers listed above for streamlined replacement
☑️ Low-power 3.3V design helps reduce overall system power and thermal load in dense deployments
This is a SATA M.2 2280 drive, not NVMe. Your system’s M.2 slot must explicitly support SATA / AHCI-based M.2 drives.
