HP 872505-001 - 400GB Solid State Drive (SSD) - SAS interface, 12Gb/s interface, 2.5-inch small form factor (SFF), mixed use (MU), smart carrier (SC), digitally signed firmware Retail
HP 390394-001 - 725 watt AC hot-plug power supply - Installs in the computer chassis as primary or redundant supply - Requires 100-240VAC at 47/63Hz Retail
HP 390547-001 - 6-bay hot-plug SATA/SAS large form-factor (LFF) hard drive cage assembly - Includes the hard drive cage with SATA/SAS backplane and backplane cables - Mounts in the lower front of the server (for tower models) or right front (for rack Retail
HP 366605-001 - NC320T PCI Express Gigabit NIC board - Has one RJ-45 connector, single port, uses copper cabling, 40KB onboard memory, supports 10/100/1000Mbps ethernet speeds, 11.43cm (4.5in) x 7.62cm (3.0in) Retail
HP A1809-90003 - HP 3000 series CS 990 family and 9000 series CS 890, and CS T500 family computers CE handbook - For HP repair use ONLY Retail
HP J2096-69011 - 32 channel RS-232C direct connect MUX board with RJ-45 connector - 32 Channel RS-232C Direct Connect MUX Board (with RJ-45 Connectors) - for the HP-PB I/O Board Slot (P/O J2096A) Retail
HP A1824-63005 - Fan assembly - 12cm (4.7in) tubeaxial fan with an attached 27.5cm (10.8in) long two wire power cable with a 3-pin (F) connector - In external I/O card cage Retail
HP A1824-63006 - Ribbon cable and power switch assembly - A 68cm (26.8in) ribbon cable with 10-pin (F) connectors on each end and one attached power switch - For power/LED - In external I/O card cage Retail
HP A3310-69001 - HP PA-RISC processor module - Includes 120MHz processor and 1MB cache - Plugs into the processor (mother) board (One or two can be plugged into each processor board) Retail
HP 0957-0061 - DC-DC converter module (Yokogawa PS601) - 185-400VDC input - +5VDC output, 130A, 650W - (Up to four modules MAY be used depending on number of processor boards installed - Used in slots P1, P10, P2 and P8) Retail
HP 0957-0060 - DC-DC converter module (Yokogawa PS603) - 185-400VDC input - 24VDC output, 325 watts - Supply for the fan power Retail
HP 0957-0057 - High voltage power supply (Astec AA50090) - 169-269VAC input, 350VDC nominal output, 6.3A, 2200W - Includes active power factor correction (PFC) and battery backup - Mounts in the right lower rear of the computer Retail
HP 0950-2246 - Switching power supply (Delta Electronics SMP-264AB REV. B) - 120/240VAC input, 50-60Hz - Three DC outputs, 260 watts - In HP-PB I/O card cage Retail
HP 0950-2232 - MPM DC to DC converter module (Yokogawa Electric Corp. PS604) - 185-400VDC input, eight DC outputs - Mounts in Slot P12 Retail
HP A3310-69002 - Processor board - Does NOT include the processor module(s) - Processor (Mother) Board - Does NOT Include the Processor Module(s) - Plugs into the Upper Card Cage (PMB) Backplane Board Retail
HP A1809-69232 - Service processor board - Service Processor Board - Plugs into the Rear (PMB) Upper Card Cage Slot (Labeled SP) Retail
HP A1809-69001 - Backplane board - Has front and rear slots for the processor(s), memory, and bus converter boards - Backplane Board - in the Center of the Upper Card Cage (PMB) - Has Front and Rear Slots for the Processor(s), Memory, and Bus Convert Retail
HP A1809-60016 - Fan controller board - Fan Controller Board - in Rear of Fan Chassis Assembly Retail
HP 2110-0902 - Fuse - 30A, 600V max - .406in dia. x 1.5in long, metal body - Fuse - 30A, 600V - Part of cable for recovery batteries Retail
HP 2110-0030M - Fuse - 5A, 250V max - .25in dia. x 1.25in long, glass body - Fuse - 5A, 250V - For battery pack - In HP-PB I/O card cage Retail
HP 3160-0809 - Tubeaxial fan (Papst-Motoren Gmbh 6224/4) - 203mm (8.0in) diameter, 51mm (2.0in) thick), 24VDC, 241CFM - Mounts in the fan chassis assembly (11 used) Retail
HP 0957-0058 - DC-DC converter module (Yokogawa PS602) - 185-400VDC input - 5VDC output, 65A, 325 watts - (Up to four modules MAY be used depending on number of memory and bus converter boards installed, in slots P5,P6,P7 and P13) Retail
HP A1809-60051 - External link cable with thumbscrews on both ends - 80-pin (M) connectors on each end - 1.0m (3.3ft) long - From Upper Bus Converter board to Lower Bus Converter board Retail
HP A1809-60049 - External link cable with thumbscrews on both ends - 80-pin (M) connectors on each end - 10m (32.8ft) long - From Upper Bus Converter board to Lower Bus Converter board mounted external of SPU Retail
HP A1809-63002 - AC power cable assembly - 15-pin (F) connector to 25cm (10in) power cord, 25cm (10in) cable with 10-pin (F) connector, and two 9cm (3.5in) ground wires with ring terminals - To power supply in HP-PB I/O card cage Retail
